HEADPHONE/EARPHONE WARNINGS
WARNING!
The molding process involves heating your molds in very hot water and forming them to your ears. Before molding, remove any piercings in the concha of the ear as the piercings may become fixed or trapped in the molding material. DO NOT PLACE THE HOT MOLD INTO YOUR EAR! Wait until the mold is warm and pliable before inserting it into the ear. Excessive heat can deform the earphones.
Permanent hearing loss may result from long-term exposure to sound at high volumes. Use as low a volume as possible. Your Decibullz have an acoustic seal, listening levels will be perceived as louder. Insert your Decibullz and set the volume low and increase as needed. The acoustic seal created by Decibullz will block out some external noise. Use of Decibullz while operating a vehicle, bicycling, or jogging may be dangerous.
CAUTION
Check that the silicone ear-canal tips are securely attached to EZ shape custom molded earpiece before every use. Remove the earphone slowly and gradually break the seal. Rapid removal may damage the eardrum. Use only as directed. If misused (by failure to use as directed), ear canal tip may become lodged in the ear, which requires removal by an Ear, Nose and Throat Doctor ONLY. Improper fitting or misuse will reduce the effectiveness and could result in hearing loss or injury.
We advise that you read the fitting instructions carefully before placing in your ear. Molds must be molded properly for maximum effectiveness.
HEAT
Do not leave in a hot car, direct sunlight, or anywhere with excessive heat. Exposing them to temperatures above 120°F/49°C could cause the EZ shape custom molds to melt and your Decibullz can become damaged.
CAUTION: CHOKING HAZARD
Keep away from children and pets. Parts are non-toxic but may interfere with breathing if caught in the windpipe.
Comments
0 comments
Article is closed for comments.